![]() ![]() The latest Cura release for the Ultimaker 3 has very good support material generation strategies too (N.B We’ve tested Scaffold with Edge on an Ultimaker 3, which works fantastically). Simplif圓D has the additional advantage of being able to manually place and remove supports which can be extremely useful. These interface layers are now available in many of the popular slicing packages out there, Slic3r, MatterControl, and Simplif圓D. Perhaps the most important of these is having solid interface layers of support material, where the final top layers of support are printed solid, not sparse. Use Notes Printing optimally with soluble and breakaway support requires specific strategies to get the best results. Dry the part - take note that there may be some water incursion into the model from soaking that can leak out over time.Clean off the remaining Scaffold with scourer pads or scrubbing brushes (for easily accessible areas) bottle brushes (for small openings).Soak for a further 2 hours or overnight.Flush out the part and clean off as much as you can.Leave submerged in water to soak for ~60 minutes.X/Y Separation Distance | 1.0mm to 0.50mm depending on the material and how well calibrated your nozzle offset isĮxtremely strong adhesion prevents breakaway but resists warpįlexibility provides very satisfying peel-away.Support Angle | 45° & -45° (create a crosshatch pattern).Bed Temperature | From 20☌ to 55C ideally, but will cope with bed temperatures as high as 110☌.However depending on your slicer, the model you are printing, and your machine you should take the following as advice and feel free to tweak to suit your particular setup and use case. The following are guidelines based on our experience with Scaffold.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |